Greetings,
I recently bought a set of the Pipedreams EzeeDrone (synthetic) drone reeds for my Whitmer drones (key of D). Since the tenor drone reed is too big to fit into the hole in the main stock I will sell the whole set for $50, plus postage. Here's the link describing the set:
http://www.pipedreamsreeds.com/shop/Eze ... 16161.html
The seat sizes of these reeds are:
Bass.................7.25mm diameter
Baritone & Tenor.....6.25mm diameter
Removing the rubber seat (which has been done on one or two of these [hemp added as a replacement] reduces the seat sizes to the following:
Bass.................6.25mm diameter
Baritone & Tenor.....5.10mm diameter
Note that the reed seats are parallel (not tapered).
With regard to the stock or chamber; this should be a minimum diameter of 12mm for the Bass and 10.5mm for the Baritone and Tenor in order to allow the reeds to function properly.
Please contact me by PM or e-mail (khankrum@hotmail.com) if interested.
Sincerely,
Dan Humphries
FS: EzeeDrone Reeds - Sold
-
Ceann Cromtha
- Posts: 883
- Joined: Mon Aug 01, 2005 5:03 pm
- antispam: No
- Please enter the next number in sequence: 8
- Tell us something.: I’m changing my location to my actual address. My previous location was a reference to Joyce’s Finnegans Wake.
- Location: Baltimore, Maryland USA
-
Ceann Cromtha
- Posts: 883
- Joined: Mon Aug 01, 2005 5:03 pm
- antispam: No
- Please enter the next number in sequence: 8
- Tell us something.: I’m changing my location to my actual address. My previous location was a reference to Joyce’s Finnegans Wake.
- Location: Baltimore, Maryland USA