It is currently Tue Oct 15, 2019 2:40 am

All times are UTC - 6 hours




Post new topic Reply to topic  [ 3 posts ] 
Author Message
 
PostPosted: Sat Apr 27, 2019 1:21 pm 
Offline
User avatar

Joined: Fri Jan 27, 2012 10:15 pm
Posts: 618
Location: Seattle, WA
On a whim yesterday I decided to try my connecting my old Walsh smallpipe set to my bellows. Having always used the Walsh (which has a synthetic reed) mouthblown, and having recently learned I was playing my other pipes at almost twice the recommended pressure, I wondered whether they'd be easier to play more gently. What I discovered was that for years, I think I had been correcting a flat top hand with changes in bag pressure. Having been practicing daily for almost six months now on an excellent bellows-powered set, my new, much steadier pressure exposed this discrepancy.

Here's what I've tried so far:
    -Made sure there was no dust or anything occluding the reed or chanter
    -Closed down the reed slightly
    -Opened the reed slightly
    -Pushed the reed further into the chanter
    -Pulled the reed further out of the chanter
    -Lightly sanded the tips of the reed blades

None of this has made any substantive impact on the problem. Sanding perhaps raised the pitch a few cents. Now, replacement Walsh reeds are only $24, but I'm learning to make smallpipe reeds (and hopefully others) and this strikes me as a good chance for education. What should I try next?


Top
 Profile  
Reply with quote  
 
PostPosted: Mon May 06, 2019 8:39 am 
Offline

Joined: Sat Jan 23, 2010 11:41 am
Posts: 210
Nobody is jumping in here, so I'll see if perhaps I can help.

With conical bore pipes, Highland and Border for example, moving the reed up and down has a greater effect on the upper hand notes than the bottom hand notes. This doesn't happen, at least to the same degree, on the cylindrical chanter of small pipes. So, it take a great degree of movement to sharpen the top hand and the whole chanter tends to go sharp at the same time.

You could try sharpening the top hand until it's in tune by pushing in the reed, and then taping the bottom holes as needed to bring them down a bit. Don't know that this will fix the problem, but you seem to have tried everything else.

The best answer may well be a new chanter reed...good luck with it! :thumbsup:

Piper Joe


Top
 Profile  
Reply with quote  
 
PostPosted: Mon May 06, 2019 9:10 am 
Offline
User avatar

Joined: Tue Jul 28, 2009 9:51 am
Posts: 493
Location: Miltown Malbay
Trim half mill off end blades and sand till it’s gets smoothe. Repeat till in tune. Gets duller in sound the more you trim. So push in till bottom A is right then trim. Good luck.

_________________
The mind is like a parachute; it only works when it is open.


Heres a few tunes round a table, first three sets;

http://soundcloud.com/fiddlerwill/werty
http://soundcloud.com/fiddlerwill/jigs-willie
http://soundcloud.com/fiddlerwill/jigs


Top
 Profile  
Reply with quote  
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 3 posts ] 

All times are UTC - 6 hours


Who is online

Users browsing this forum: No registered users and 11 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group
[ Time : 0.152s | 12 Queries | GZIP : On ]
(dh)