Page 1 of 1

chanterreed

Posted: Sat Jan 23, 2021 10:20 am
by pipemaker
I am restoring an old chanter and discovered it has the exact measurements as the Coyne D chanter. The soundholes were badly enlarged with a knife or maybe a scissor.I have a drawing of the original Coyne chanter .Lenght is 373 mm and the fingerholes have a width between 5 and 3.8 mm. ( mostly 4.9 mm) So I filled the old soundholes( 2 were almost 9 mm) with a mixture of resin and ebonydust and redrilled the chanter with the exact mesurement on the drawing and soundhole diameters..
Next challenge is the reed I need.

Who can supply me a reed for the narrow bore Coyne chanter or can help me to contact a good reedmaker .

Thanks.

Frans

Re: chanterreed

Posted: Sat Jan 23, 2021 2:29 pm
by an seanduine
Frans, my memory is a little unclear here, so bear with me. Kevin Rowsome has, or had, a chanter that was described as either a Harrington or Coyne of about that measurement (373 mm.). You might reach out to him for this information. Just a possibility.

Bob