Chiff and Fipple Forums
http://forums.chiffandfipple.com/

Has anyone been to Federal Flange?
http://forums.chiffandfipple.com/viewtopic.php?f=24&t=60377
Page 1 of 1

Author:  Flyingcursor [ Wed Jun 04, 2008 1:08 pm ]
Post subject:  Has anyone been to Federal Flange?

Here's a place in Houston TX that has a showroom full of flanges.

http://www.federalflange.com/english/index1.php

Check out image #2. It looks like they sell low D flanges.

I wondered if anyone here from Texas has gone there. Do they let you try out the flanges in the showroom?

I'm thinking of ordering a ASME B16.36 - Slip-On Orifice Flange.

Author:  Denny [ Wed Jun 04, 2008 2:20 pm ]
Post subject: 

uh huh, slip-on or threaded?

Author:  Nanohedron [ Wed Jun 04, 2008 2:22 pm ]
Post subject: 

Denny wrote:
uh huh, slip-on or threaded?


C'mon, he said slip-on. Threaded's gonna hurt. Everyone knows that.

Author:  Dale [ Wed Jun 04, 2008 2:38 pm ]
Post subject: 

Beautiful flanges. beautifully presented. Thank you.

Dale

Author:  Denny [ Thu Jun 05, 2008 6:42 am ]
Post subject: 

Nanohedron wrote:
Denny wrote:
uh huh, slip-on or threaded?


C'mon, he said slip-on. Threaded's gonna hurt. Everyone knows that.

the mind is going, innit....
this is so depressing,
dang nice flanges though!

Author:  Flyingcursor [ Thu Jun 05, 2008 10:31 am ]
Post subject: 

I've changed my mind. I'll probably get the ring-joint flange instead. I've heard it's not as shrill in the high-octave.

Page 1 of 1 All times are UTC - 6 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/