Page 1 of 1

Has anyone been to Federal Flange?

Posted: Wed Jun 04, 2008 1:08 pm
by Flyingcursor
Here's a place in Houston TX that has a showroom full of flanges.

http://www.federalflange.com/english/index1.php

Check out image #2. It looks like they sell low D flanges.

I wondered if anyone here from Texas has gone there. Do they let you try out the flanges in the showroom?

I'm thinking of ordering a ASME B16.36 - Slip-On Orifice Flange.

Posted: Wed Jun 04, 2008 2:20 pm
by Denny
uh huh, slip-on or threaded?

Posted: Wed Jun 04, 2008 2:22 pm
by Nanohedron
Denny wrote:uh huh, slip-on or threaded?
C'mon, he said slip-on. Threaded's gonna hurt. Everyone knows that.

Posted: Wed Jun 04, 2008 2:38 pm
by Dale
Beautiful flanges. beautifully presented. Thank you.

Dale

Posted: Thu Jun 05, 2008 6:42 am
by Denny
Nanohedron wrote:
Denny wrote:uh huh, slip-on or threaded?
C'mon, he said slip-on. Threaded's gonna hurt. Everyone knows that.
the mind is going, innit....
this is so depressing,
dang nice flanges though!

Posted: Thu Jun 05, 2008 10:31 am
by Flyingcursor
I've changed my mind. I'll probably get the ring-joint flange instead. I've heard it's not as shrill in the high-octave.