It is currently Thu Oct 22, 2020 5:41 pm

All times are UTC - 6 hours




Post new topic Reply to topic  [ 1 post ] 
Author Message
 
PostPosted: Sun Oct 04, 2020 12:36 pm 
Offline
User avatar

Joined: Thu Apr 07, 2005 9:55 pm
Posts: 205
Location: Pueblo, Colorado USA
I received this cane flute from a dealer and when I got it instead of Key G it was Key G# but very sharp. None of the notes were correct so I decided since he did not want it back it was probably because to him it was useless. I figured since I had it I might as well experimenting with it. I first had to add a 14mm piece of cane to it to get it into the key of G. Then I filled all the holes except for the embouchure to close off any air leaks. The G note sounds so good it is awesome but I am trying to figure out where to drill the holes. I am wondering if I should use a ratio of tube length measuring from the center of the embouchure to the tube end for each hole after figuring out the ratio on another whistle or flute with a near similar 18mm id and 2.2mm wall thickness. This is what I am starting with. I know it may be a little difficult but figured I have nothing to loose. Any advice would be appreciated. I have tried some online flutomat calculators and find them useless.

https://flic.kr/p/2jPkVg8


Top
 Profile  
Reply with quote  
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 1 post ] 

All times are UTC - 6 hours


Who is online

Users browsing this forum: Bing [Bot], Google and 10 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group
[ Time : 0.061s | 12 Queries | GZIP : On ]
(dh)