Chiff and Fipple Forums
http://forums.chiffandfipple.com/

Split common stock?
http://forums.chiffandfipple.com/viewtopic.php?f=19&t=97133
Page 1 of 1

Author:  ckrusor [ Sat Mar 08, 2014 12:15 am ]
Post subject:  Split common stock?

Has anyone seen an example of a removable common stock on a set of smallpipes? I'm imagining something similar to a split chanter stock.

Author:  pancelticpiper [ Sat Mar 08, 2014 7:42 am ]
Post subject:  Re: Split common stock?

The John Walsh "Smallpipes in A 2000" have something like that.

On the set I had you could remove the end part which held all the drones, so that you could adjust reeds without removing the drone lower section from the stock.

Another interesting thing about that set was that there were no separate drone reeds: the body of the synthetic reed was machined in the same piece as the drone 'standing section'.

Really a brilliant design which worked perfectly.

Image

Author:  AaronMalcomb [ Sun Mar 09, 2014 4:10 am ]
Post subject:  Re: Split common stock?

Yes, a version of the split-stock exists for drones that splits near bag and that keeps the reeds enclosed. It's usually an added option. It has a lot of practical benefits though it's the joint that will wreak the most havoc if it's at all loose.

Author:  MTGuru [ Mon Mar 10, 2014 12:34 pm ]
Post subject:  Re: Split common stock?

We're glad this thread is not about financial investment. :) - Mod

Author:  ckrusor [ Wed Mar 12, 2014 11:39 pm ]
Post subject:  Re: Split common stock?

Thanks for those examples. I also found that Seth Hamon's smallpipes have the same kind of removable common stock. This image is from his site:

Image

I'm gradually making my first set of smallpipes and the idea of a removable common stock occurred to me, but I hadn't seen an example. It's interesting that all of these makers seem to do it the same way. I imagined the stock itself coming off with the drones from a "port" on the bag. I think I might try the kind I had in mind and accept the risk of learning the hard way the reasons for doing it the way the experienced makers do it.

Author:  AaronMalcomb [ Fri Mar 14, 2014 10:29 pm ]
Post subject:  Re: Split common stock?

Not sure if the way Walsh and Hamon do it is typical. If you look at the picture Ian Lawther posted in the other forum, that is probably more typical. The exposed reed style has some appeal. Trying to pull an individual drone out of the stock can be a feat of fingertip strength when you want to adjust a reed. But if your swapping stocks like NSP-to-SSP or SSP-to-Reelpipes, having those reeds safe in the comfort of the common stock is worth the exertion on the fingertips.

Page 1 of 1 All times are UTC - 6 hours
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/